Reed, EPI and denting are written on every job card, yet they are easy to mix up. This guide explains each and how they connect.
What is the reed?
The reed is the comb-like part of the loom that spaces the warp ends and beats each pick into place. Its gaps are called dents, and the warp ends are drawn through them in groups.
Reed count
In Indian mills the reed count usually follows the Stockport system: the number of dents in 2 inches. An 88 reed has 88 dents per 2 inches, i.e. 44 dents per inch.
Ends per dent and EPI
Each dent carries a fixed number of ends — usually 2 in cotton shirting. Ends per inch follows directly:
EPI = reed count × ends per dent ÷ 2
- 88 reed, 2 ends per dent → 88 × 2 ÷ 2 = 88 EPI (often written "88/2")
- 44 reed, 2 ends per dent → 44 EPI
- 72 reed, 3 ends per dent → 108 EPI
Note that a bare "88" on a card usually already means 88 EPI; "88/2" spells out the reed and denting that give it. When in doubt, check against the total ends.
Reed space and total ends
Reed space is the width of the warp in the reed, in inches. It is wider than the finished cloth because the fabric draws in on the loom and shrinks in processing.
Total ends = EPI × reed space + selvedge ends
Example: 88 EPI × 63″ = 5,544 ends, plus 32 selvedge ends = 5,576 ends on the beam.
Denting plan
The denting plan says how many ends go in each dent across the repeat — for example 2-2-2-3 to crowd extra ends into a stripe, or 1 per dent for a more open effect. Uneven denting changes the look of the cloth without changing the reed.
Why it matters
- EPI drives warp weight, cover factor and cost — a wrong reed reading means a wrong costing
- Reed space sets total ends, and with it warping and beam planning
- Denting affects streakiness, reed marks and how the fabric drapes
Plug your reed, pick and reed space into the free textile calculator to get yarn weight, GSM and cost. Related: cover factor explained.